Using Volcano Plots to Compare Vinyl Acetate Resin Samples Measured by Pyrolysis GC-MS March 5, 2020 AccuTOF™ GC, Application Note, Mass Spectrometry (MS), Materials 0 Introduction Advances in mass spectrometry are enabling analysis of micro samples and unknown components that were not observable before. As the volume of information acquired from mass spectrometry increases, researchers are calling for simple techniques to analyze the numerous components observed, and as a result, there is a rise in demand for comprehensive analytical techniques including multiple classification analysis. In this work, we analyzed 2 samples in a high resolution GC-TOFMS, using EI, the most widely used ionization technique for GC-MS, and compared the data acquired by using a comprehensive analytical technique. Experiment As model samples, 6 commercial vinyl acetate resins (adhesives) were used. A gas chromatography time-of-flight mass spectrometer (GC-TOFMS) was used for the measurements. Since emulsion samples including adhesives are difficult to analyze without preliminary treatment, the samples were subjected to pyrolysis. Also, a column shorter than a typical GC column was used along with a Fast GC temperature sequence to speed up the measurement process. The data acquired was examined using SpectralWorks Analyzer Pro, and 2 samples were compared by the Volcano Plot. Table 1 shows the pyrolysis fast GC/TOFMS measurement conditions. For full details: Attached files often contain the full content of the item you are viewing. Be sure and view any attachments. Using Volcano Plots to Compare Vinyl Acetate Resin Samples Measured by Pyrolysis GC-MS.pdf 308.15 KB Showing 0 Comment Comments are closed.